» » ยป

ABS Repair Billings MT

Antilock braking systems (ABS) can provide more steering control, help avoid skidding, improve vehicle control, decrease stopping distances, and prevent wheel locking. ABS repair is available if the ABS is not performing these functions. See below for local auto service providers in Billings, MT who provide access to ABS repair, anti-lock braking system diagnosis as well as related content on antilock braking systems.

Jims Auto Repair
(406) 248-3701
2315 6th Avenue North
Billings, MT
Services
Brake Repair

Big Rig Truck and Trailer Repair
(406) 252-8413
1307 Taylor Place
Billings, MT
Services
Brake Repair,Trailer Repair

Precision Automotive
(406) 248-2838
138 Moore Lane
Billings, MT
Services
AC and Heating Repair,Brake Repair,Electrical Repair,Mufflers Repair

Edams Tire and Automotive
(406) 545-0169
2503 1st Avenue North
Billings, MT
Services
AC and Heating Repair,Brake Repair

A To Z Tire and Battery Inc
(406) 245-7781
912 4th Avenue North
Billings, MT
Services
Brake Repair

Valley Auto Service Center
(406) 256-3970
2924 1st Avenue North
Billings, MT
Services
AC and Heating Repair,Brake Repair,Electrical Repair,Mufflers Repair

Brake Shop
(406) 259-8622
2211 4th Avenue North
Billings, MT
Services
Brake Repair

Montana Tire Distributors
(406) 259-9877
421 N 13th Street
Billings, MT
Services
Brake Repair

Russiff Auto Service Inc
(406) 252-1225
3409 Montana Avenue
Billings, MT
Services
Brake Repair,Diagnostic Services

Midas Auto Service Experts
(406) 252-0116
2702 4th Avenue North
Billings, MT
Services
Oil Change and Lube,Brake Repair,Electrical Repair,Mufflers Repair

ABS Brake Issues

Provided by:

Reader Question: I have a 2002 Audi A6 2.7T Quattro. It has 56,000 miles on it. I purchased it about 8 months ago. I love the car but in the end of October, I was driving and the ABS/ESP lights came on, after I had turned the car off and back on they went out.

A month or so later my husband took the car after a cold night, the emergency brake had been on, and he said it felt like the brakes were on and holding him back. Over the next few month it happened some more until one day, I was driving and the lights came back on and it felt like the brakes were being applied and the pedal went hard as a brick.

I brought to my mechanic and of course, when he got in it everything was fine again. I took it home and a few days later I went to leave my driveway and the pedal was hard as a brick so I had it towed, they could not find any codes in the computer so the kept the car and drove it and since then it has happened several more times.

They have bled the brakes and replace a valve next to the booster and the brake switch and it still happened and now we are moving on to replace the brake booster and master cylinder and a very large bill, I just would like your opinion on this if you think this could be the problem.

I am worried that it could be the ABS system or a hydraulic
Issue, the mechanic did tell me that they discounted the ABS system and it still happened. Any help!

Thanks,

Gretchen

Hi Gretchen,

I am not very familiar with these ABS systems, and that could be the problem with your mechanic. They are not familiar with them either. I would suspect you do have a problem with the ABS pump, which supplies hydraulic fluid pressure to the system. However, that is an expensive GUESS!

The problem will probably be trying to get a diagnosis when the ABS light is ON. Each time you turn the key off, the on board computer system will reset itself and try to clear out any trouble codes that might have been stored in memory. Therefore, when your mechanic plugs his test equipment in he sees nothing.

To read the full article, visit Myhonestmechanic.com

Home | About | Contact | Register Your Company