» » ยป

Chrysler Service Alexandria LA

See below for Chrysler services in Alexandria. Among the available resources you will find detailed information on local businesses that give access to Chrysler repair, Chrysler oil changes, collision parts, repair parts, rebuilt suspension, engine repair and transmission repair, as well as advice and content on Chrysler maintenance and Chrysler restoration.

Jiffy Lube
(318) 448-6181
7 Texas Ave
Alexandria, LA
Hours
Sun: CLOSED
Mon-Fri: 8:00 AM-6:00 PM
Sat: 8:00 AM-5:00 PM

Jiffy Lube
(318) 448-0850
3837 Alexandria Mall Dr
Alexandria, LA
Hours
Sun: CLOSED
Mon-Sat: 7:30 AM-6:00 PM

Texaco Gas Station
(318) 473-4131
5203 Jackson Street Ext
Alexandria, LA
Services
Service Stations,Gas Stations

Chevron Gas Station
(318) 561-0043
5003 Lee St
Alexandria, LA
Services
Service Stations,Gas Stations

Jiffy Lube
(318) 641-1244
3206 MONROE HWY
PINEVILLE, LA
 
Jiffy Lube
(318) 484-3718
5115 MASONIC DRIVE
ALEXANDRIA, LA
 
Jiffy Lube
(318) 473-9901
4107 Parliament Dr
Alexandria, LA
Hours
Sun: CLOSED
Mon-Fri: 8:00 AM-6:00 PM
Sat: 8:00 AM-5:00 PM

Price Auto Electric
(318) 445-6271
1601 Metro Dr
Alexandria, LA
Services
Auto Parts,Service Stations,Truck Repair

Jiffy Lube
(318) 473-4027
205 Edgewood Dr
Pineville, LA
Hours
Sun: CLOSED
Mon-Fri: 8:00 AM-6:00 PM
Sat: 8:00 AM-5:00 PM

Jiffy Lube Market Ofc
(318) 484-6143
3837 Alexandria Mall Dr
Alexandria, LA
Services
Oil Change and Lube, Automotive Transmission

High Engine RPM and Stalling

Provided by:

Reader Question
Dear Austin I enjoyed reading you website, I'm also in need of some expert advice.

I have a 96 Chevy Lumina V6 3.4L engine with over 142,000 miles.

These are my problems:

The check engine light is on

When I start the it up the RPM rushes high to around 3,000 sometimes it cuts off on me when I slowdown

It has an engine oil leak

I got a diagnostic at Meineke:
They said that the computer reads code P0102,P0171. They said that the Mass Air Flow Sensor is the reason the car is cutting off.

They said that my computer reads transmission is slipping they also said I need to replace the transmission line and transmission pan gasket and then the engine oil leak will stop.

Then I brought my car to a transmission specialist which also did a diagnostic: they said that my transmission is fine and my car rides smooth.

Then I brought it into Shell gas station, they said my car might be cutting off, because my engine isn't mounted down which means too much air is getting into my system which then causes my car to shut off because gas and air are not mixing correctly.

They tighened some loose vacuum lines and cleaned my IAC, but my car is still cutting off. Can you please give me some suggestions,

Thank You

Hello There, I feel your pain!!!

Thanks for your email and your kind words. Hummmmm. I assume that the high idle problem was solved with cleaning the IAC motor (Idle Air Control). Did they clean the throttle body as well?

If not I would have that shop check to see if the throttle body is dirty and needs cleaning....if dirty it can cause stalling, and erratic idle speed....but usually wont turn on the check engine light.

The check engine light, from the codes you mentioned, could be due to a bad Mass Air Flow Sensor. They do offer a remanufactured sensor which will save you a lot of money, so you might ask them about it.

To read the full article, visit Myhonestmechanic.com

Home | About | Contact | Register Your Company