» » ยป

Chrysler Service Bangor ME

See below for Chrysler services in Bangor. Among the available resources you will find detailed information on local businesses that give access to Chrysler repair, Chrysler oil changes, collision parts, repair parts, rebuilt suspension, engine repair and transmission repair, as well as advice and content on Chrysler maintenance and Chrysler restoration.

VIP Parts Tires Service
(207) 989-1280
500 Wilson St
Brewer, ME
Services
Auto Parts,Brake Repair,Clutch Repair,Emissions Testing,Engine Repair,Retail Tire,Service Stations

Mobile Lube
(207) 570-3319
46 Oxbow
Bangor, ME
Services
Oil Change and Lube,Mobile Auto Repair

VIP Parts Tires and Service
(207) 827-7012
947 Stillwater Ave
Old Town, ME
Services
Auto Parts,Brake Repair,Clutch Repair,Emissions Testing,Engine Repair,Retail Tire,Service Stations

Lampron Energy
(207) 781-5019
251 Us Route 1
Falmouth, ME
Services
Service Stations,Gas Stations

Main Street Mobil
(207) 743-9852
185 Main Street
South Paris, ME
Services
Service Stations

VIP Parts Tires and Service
(207) 827-7012
947 Stillwater Ave
Old Town, ME
Services
Auto Parts,Brake Repair,Clutch Repair,Emissions Testing,Engine Repair,Retail Tire,Service Stations

Murrays Service Center
(207) 866-0029
19 College Avenue
Orono, ME
Services
Oil Change and Lube,AC and Heating Repair,Auto Repair,Brake Repair,Electrical Repair,Mufflers Repair

Bohanons Service INC
(207) 427-3830
Houlton Rd
Baileyville, ME
Services
Service Stations,Gas Stations

Hamiltons Service Station
(207) 773-1930
205 Park Ave
Portland, ME
Services
Oil Change and Lube,Auto Repair,Brake Repair,Electrical Repair,Mufflers Repair,Retail Tire,Service Stations,Truck Repair

C and J Service Center
(207) 328-7645
996 Access Hwy
Caribou, ME
Services
Towing Service,Service Stations,Gas Stations

High Engine RPM and Stalling

Provided by:

Reader Question
Dear Austin I enjoyed reading you website, I'm also in need of some expert advice.

I have a 96 Chevy Lumina V6 3.4L engine with over 142,000 miles.

These are my problems:

The check engine light is on

When I start the it up the RPM rushes high to around 3,000 sometimes it cuts off on me when I slowdown

It has an engine oil leak

I got a diagnostic at Meineke:
They said that the computer reads code P0102,P0171. They said that the Mass Air Flow Sensor is the reason the car is cutting off.

They said that my computer reads transmission is slipping they also said I need to replace the transmission line and transmission pan gasket and then the engine oil leak will stop.

Then I brought my car to a transmission specialist which also did a diagnostic: they said that my transmission is fine and my car rides smooth.

Then I brought it into Shell gas station, they said my car might be cutting off, because my engine isn't mounted down which means too much air is getting into my system which then causes my car to shut off because gas and air are not mixing correctly.

They tighened some loose vacuum lines and cleaned my IAC, but my car is still cutting off. Can you please give me some suggestions,

Thank You

Hello There, I feel your pain!!!

Thanks for your email and your kind words. Hummmmm. I assume that the high idle problem was solved with cleaning the IAC motor (Idle Air Control). Did they clean the throttle body as well?

If not I would have that shop check to see if the throttle body is dirty and needs cleaning....if dirty it can cause stalling, and erratic idle speed....but usually wont turn on the check engine light.

The check engine light, from the codes you mentioned, could be due to a bad Mass Air Flow Sensor. They do offer a remanufactured sensor which will save you a lot of money, so you might ask them about it.

To read the full article, visit Myhonestmechanic.com

Home | About | Contact | Register Your Company