Chrysler Service Council Bluffs IA

See below for Chrysler services in Council Bluffs. Among the available resources you will find detailed information on local businesses that give access to Chrysler repair, Chrysler oil changes, collision parts, repair parts, rebuilt suspension, engine repair and transmission repair, as well as advice and content on Chrysler maintenance and Chrysler restoration.

Jiffy Lube
(712) 328-3229
Sun: 10:00 AM-3:00 PM
Mon-Fri: 8:00 AM-6:00 PM
Sat: 8:00 AM-5:00 PM
Store Holiday Hours
Mother's Day: 10:00 AM-3:00 PM

Griffs Sinclair Service
(402) 731-9456
3536 Q St
Omaha, NE
Fuel Injection Repair,Service Stations,Gas Stations

Freds Friendly Service
(402) 342-9519
2901 Leavenworth St
Omaha, NE
Fuel Injection Repair,Service Stations,Gas Stations

Jiffy Lube
(402) 556-4815
Sun: 9:00 AM-3:00 PM
Mon-Thu: 7:00 AM-7:00 PM
Fri: 7:00 AM-6:00 PM
Sat: 7:00 AM-5:00 PM

Jiffy Lube
(402) 733-0595
Sun: 9:00 AM-5:00 PM
Mon-Fri: 7:00 AM-7:00 PM
Sat: 7:00 AM-5:00 PM

Sinclair Gas Station
(402) 342-3903
901 N 24th St
Omaha, NE
Service Stations,Gas Stations

Stolls 66 Service
(402) 553-9669
3824 Farnam St
Omaha, NE
Fuel Injection Repair,Service Stations,Gas Stations

Meineke Car Care Center
(402) 575-9176
3322 Leavenworth St
Omaha, NE
Service Stations

Dobneys Sinclair
(402) 451-0838
7118 N 30th St
Omaha, NE
Towing Service,AC and Heating Repair,Service Stations,Gas Stations

Teds Sinclair
(402) 558-5420
4525 Center St
Omaha, NE
Service Stations,Gas Stations

High Engine RPM and Stalling

Provided by:

Reader Question
Dear Austin I enjoyed reading you website, I'm also in need of some expert advice.

I have a 96 Chevy Lumina V6 3.4L engine with over 142,000 miles.

These are my problems:

The check engine light is on

When I start the it up the RPM rushes high to around 3,000 sometimes it cuts off on me when I slowdown

It has an engine oil leak

I got a diagnostic at Meineke:
They said that the computer reads code P0102,P0171. They said that the Mass Air Flow Sensor is the reason the car is cutting off.

They said that my computer reads transmission is slipping they also said I need to replace the transmission line and transmission pan gasket and then the engine oil leak will stop.

Then I brought my car to a transmission specialist which also did a diagnostic: they said that my transmission is fine and my car rides smooth.

Then I brought it into Shell gas station, they said my car might be cutting off, because my engine isn't mounted down which means too much air is getting into my system which then causes my car to shut off because gas and air are not mixing correctly.

They tighened some loose vacuum lines and cleaned my IAC, but my car is still cutting off. Can you please give me some suggestions,

Thank You

Hello There, I feel your pain!!!

Thanks for your email and your kind words. Hummmmm. I assume that the high idle problem was solved with cleaning the IAC motor (Idle Air Control). Did they clean the throttle body as well?

If not I would have that shop check to see if the throttle body is dirty and needs cleaning....if dirty it can cause stalling, and erratic idle speed....but usually wont turn on the check engine light.

The check engine light, from the codes you mentioned, could be due to a bad Mass Air Flow Sensor. They do offer a remanufactured sensor which will save you a lot of money, so you might ask them about it.

To read the full article, visit

Home | About | Contact | Register Your Company